AIRTRONICS SD-10G Operating Manual page 102

aero Flight Mode menu
1) Press the Navigation Pad 56 to highlight MIXING, then press the
ENTER key to display the MIXING menu. The FLAPERON sub-menu
will be highlighted by default.
2) Press the Navigation Pad 6 to highlight RU 4 AI, then press the
ENTER key to display the RU 4 AI menu. The cursor will default to
COMMON>COM.
3) Press the YES/+ or NO/- keys to choose the desired COM or SEP
option as described previously.
4) Press the Navigation Pad 6 to highlight RU-L 4 AI>0%.
5) Press the YES/+ or NO/- keys to change the Rudder-Left 4 Aileron
mixing percentage value.
6) Press the Navigation Pad 6 to highlight RU-R 4 AI>0%, then press the
YES/+ or NO/- keys to change the Rudder-Right 4 Aileron mixing
percentage value.
The Rudder 4 Aileron mixing percentage value is a ratio of aileron travel to rudder travel. For example, when the
Rudder-Left 4 Aileron and the Rudder-Right 4 Aileron mixing percentage values are set to 10%, the ailerons will travel
1/10th the amount that the rudder travels in both directions. This mix is Linear.
RU-L 4 AI and RU-R 4 AI setting range is -100% to 100%. The default settings are 0%. When the percentage values are
increased from 0% to 100%, aileron travel will increase in one direction in relation to rudder travel. When the percentage values
are decreased from 0% to -100%, aileron travel will increase in the opposite direction in relation to rudder travel.
The channel options displayed will vary based on Model Type and Model Type selection options currently selected. For
example, if your model features dual aileron servos, RU-L/R 4 LA (Left Aileron) and RU-L/R 4 RA (Right Aileron) percentage
values can be changed separately.
Because you can program the Rudder 4 Aileron percentage value separately for both directions of rudder travel, it's
possible to program the mix to either make the ailerons move up or down with right and left rudder control, make the ailerons
move up and down with right and left rudder control, or make the ailerons move up or down with right or left rudder control.
Rudder to Throttle Mixing
The Rudder to Throttle Mixing function allows you to mix a percentage of throttle control with rudder control. When you move the
rudder right or left, the throttle will increase or decrease. The Rudder to Throttle Mixing function is typically used on twin-engine
aircraft to vary the throttle of each engine while taxiing. If can also be used to increase power during turns while taxiing. This is
helpful for float planes or scale aircraft. The amount and the direction that the throttle moves with rudder control is adjusted by
changing the Rudder 4 Throttle mixing percentage value either positive or negative. Separate mixes can be programmed for right
and left rudder throw.
IMPORTANT The Rudder to Throttle Mixing function must be assigned to a Switch Position Number before it can be
Activated. For more information, see page 45.
1) Press the Navigation Pad 56 to highlight MIXING, then press the ENTER key to display the MIXING menu. The FLAPERON
sub-menu will be highlighted by default.
2) Press the Navigation Pad 6 to highlight RU 4 TH, then press the
ENTER key to display the RU 4 TH menu. The cursor will default to
COMMON>COM.
3) Press the YES/+ or NO/- keys to choose the desired COM or SEP
option as described previously.
Page 102