Cdly (Cp3 Channel Delay - Heli Model Type Only); Sdly (Ccpm Servo Delay - Heli Model Type Only) - AIRTRONICS SD-10G Operating Manual

surface MENU

cDLY (cp3 cHannEL DELaY - HELi MODEL TYpE OnLY)

The CP3 Delay function allows you to slow down the two forward channels when using CCPM. For example, on some helicopters,
when using CCPM you will find that the elevator is a little more sensitive than the ailerons. You can use the CP3 Delay function
to slow down the two forward channels to fine-tune the feel of the swashplate controls. The goal is to adjust elevator control to
feel the same as aileron control and vice-versa depending on the Swashplate Type selected.
Changing CP3 Delay Adjustment Values
1) Press the Navigation Pad 3456 to highlight the CDLY Adjustment
Value for the channel that you would like to change.
2) Press the YES/+ or NO/- keys to change the CDLY Adjustment Value.
CDLY setting range is 0% to 100%. The default setting is 0%. Increasing the CDLY Adjustment Value slows down the two
forward channels and decreasing the CDLY Adjustment Value returns the two forward channels toward their normal speed.
When the CDLY Adjustment Value is set to 0%, the two forward channels will operate at their normal speed.
The CP3 Delay function can be adjusted on the Swashplate Types and the Channels shown in the table below.

SDLY (ccpM SERvO DELaY - HELi MODEL TYpE OnLY)

The CCPM Servo Delay function allows you to adjust the speed of the elevator, aileron, and pitch servos independently. Even
though the servos may be of the same type, not all servos operate at the same exact speed. If one or more servos controlling
the swashplate is operating faster than another servo, this can cause swashplate geometry issues and even result in binding of
the swashplate linkage assemblies. For example, adjusting the CCPM Servo Delay to slow down the faster servo(s) to match the
slower servo(s) helps to fine-tune the swashplate, ensuring the most accurate and smoothest movement as possible throughout
the entire deflection range. If desired, you could slow down each of the servos the same percentage to slow the overall feel of
the swashplate controls.
Changing CCPM Servo Delay Adjustment Values
1) Press the Navigation Pad 3456 to highlight the SDLY Adjustment
Value for the channel that you would like to change.
2) Press the YES/+ or NO/- keys to change the SDLY Adjustment Value.
3) Adjust the desired remaining SDLY Adjustment Values using the same
techniques.
SDLY setting range is 0% to 100%. The default setting is 0%. Increasing the SDLY Adjustment Value slows down the servo in
both directions and decreasing the SDLY Adjustment Value speeds up the servo in both directions.
When the SDLY Adjustment Value is set to 0%, the servo will operate at is normal speed.
SWASHPLATE TYPE
CP3F
CP3B
CP3R
CP3L
Page 69
CH
EL
EL
AI
AI