AIRTRONICS SD-10G Operating Manual page 187

heli Flight Mode menu
18.c-Mix (cOMpEnSaTiOn Mixing)
The C-Mix function allows you to program custom mixes that can control any number of desired functions in different combinations.
It is used to create your own custom mix if one of the pre-programmed mixes is not suitable.
Like with pre-programmed mixes, Compensation Mixes are composed of a Master channel and a Slave channel. The Master
channel always controls the Slave channel. Any of the available ten channels can be programmed as a Master or a Slave. The
same channel can even be programmed as both a Master and a Slave. The C-Mix function includes nine custom-programmable
Points to ensure an extremely precise channel Curve to suit any situation. You can also program a Delay for the Slave function
that works independently (or with) the dedicated Channel Delay function described on page 172.
Up to five C-Mix functions can be programmed separately for each of the five Flight Modes or you can use the same C-Mix
programming across all five Flight Modes. An Input and Output display, along with a graph, help with programming visualization.
In all cases, the Master channel always controls the Slave channel. In the default configuration, all Compensation Mixes
can be programmed to be Linear, or precise channel Curves can be created by programming up to nine Points along
the Curve.
Transmitter F-MODE
Programming F-MODE
Transmitter F-MODE refers to the Flight Mode that the transmitter is currently operating in. Programming F-MODE refers
to the Flight Mode that you would like to change the programming for.
IMPORTANT Each C-Mix function must be assigned to a Switch Position Number before it can be Activated. For more
information, see page 45.
Choosing the Compensation Mixing Number
Up to five separate Compensation Mixing functions can be programmed for each Flight Mode, however, only one Master/Slave
channel can be assigned to one Compensation Mixing function at a time.
More than one Compensation Mixer can be assigned to the same Switch Position Number, so that they can be Activated at
the same time. For example, assign both C-Mix 1 and C-Mix 2 to Switch Position 5 to Activate both Compensation Mixers
at the same time.
1) Press the Navigation Pad 56 to highlight C-MIX, then press the ENTER
key to display the C-MIX menu. The cursor will default to C-MIX>1.
2) Press the YES/+ and NO/- keys to choose the C-MIX number you would
like to program Compensation Mixing for.
C-MIX setting range is 1, 2, 3, 4, or 5. The default setting is 1.
Function Output (O)
150%
100%
0%
100%
150%
Point Positions
Page 187
Stick Input (I)