AIRTRONICS SD-10G Operating Manual page 196

TROUBLESHOOTING GUIDE
PROBLEM
Inadequate transmitting range
Servo will not move to the end of its range
Safety Link system not functioning
Cannot copy programming data
Cannot copy Flight Mode programming data
Custom menu display empty
PACK NOT READY!! message displayed
when Initializing Memory Expansion Card
Cannot change Surface menu Adjustment
Values
Control linkages bind when using the available
pre-programmed mixes or a C-Mix
Servo moves too much, or doesn't move
enough, when trim switch is moved
Drastic control changes when switching
between Flight Modes
One or more mixes do not function
Control surface trim changes when switching
between Flight Modes
Transmitter/receiver range check fails
Camber trim changes when you change
camber percentage value
CAUSE
Battery not fully charged
Receiver antennas not mounted
correctly in your model
Transmitter in Low Power mode
T r a n s m i t t e r o p e r a t i n g i n
Trainer>Slave mode
Servo Limit Adjustment Value
set too low
Safety Link number does not
match Model Memory number
Using FHSS-1 receiver
Attempting to copy programming
data to the same model memory
number
Attempting to copy Flight Mode
programming data to the same
Flight Mode number
No shortcuts added to Custom
menu
Memory Expansion Card not
installed
Adjustment Options Lock is
engaged
Mixes can cause servos to move
beyond the programmed EPA
Adjustment Values
Trim Step resolution requires
adjustment to suit your preference
Flight Mode Delay function not
utilized
Mixes not assigned to switch
Trim set to SEP in Trim Flight
Mode menu
Low transmitter and/or receiver
batteries
Receiver antennas not mounted
correctly in your model
Aircraft sitting in tall grass
(usually sailplanes only)
Camber Point is incorrect
Page 196
SOLUTION
Fully charge battery
Mount receiver antennas as recommended
Inhibit Low Power mode to operate in Normal
mode
Inhibit the Trainer function to use transmitter
normally
Adjust servo Limit Adjustment Value in the
surface menu
Change Safety Link number to match Model
Memory number of current model
Use FHSS-3 receiver. Safety Link is compatible
only with FHSS-3 receivers.
Copy programming data to a different model
memory number
Copy Flight Mode programming data to a
different Flight Mode number
Add shortcuts to your favorite menus by
highlighting the desired menu, then pressing
the YES/+ key
Install Memory Expansion Card and make sure
it's fully seated into position
Inhibit Adjustment Options Lock
Use the Limits function in the Surface menu to
set the maximum allowable travel of your servo
Adjust Trim Step resolution to suit your
preference
Program Flight Mode Delays to smooth the
transition of servo movement when switching
between Flight Modes
Assign mixes to a switch (or switches).
Set Trim to COM in Trim Flight Mode menu
Fully charge transmitter and receiver batteries
Mount receiver antennas as described
Lift model out of grass for range check
With the Camber Preset percentage value set
to 0%, Auxiliary Lever (VR6) must be centered.
With the percentage value set to 100%, the
bottom of Auxiliary Lever (VR6) must be
pushed all the way forward. With the percentage
value set to -100%, the bottom of Auxiliary
Lever (VR6) must be pulled all the way back