F-Mode Copy (Flight Mode Programming Data Copy) - AIRTRONICS SD-10G Operating Manual

glid Flight Mode menu
Choosing Channel VR Assignments
1) Press the Navigation Pad 5634 to highlight the channel you would
like to change the VR Assignment for, then press the YES/+ or NO/- keys
to change the VR Assignment.
VR ASSIGN setting range is ---, STK, VR5, VR6, and VR7. The default setting for CAMBER is VR6. The default setting for FLAP
is STK, and the default setting for AUX1 is VR7. The default settings for MOTOR, AUX2 and AUX3 is ---.
To disable an Auxiliary Lever, Auxiliary Dial Knob or the control stick, assign --- to the desired channel. For example, if you
don't want Auxiliary Lever (VR6) to control Camber, change CAMBER>VR6 to CAMBER> --- .
IMPORTANT Both sides of each auxiliary channel (High and Low), can be assigned to a Switch Position Number, using the
SW ASSIGN menu. If the Flap and Motor channels, or an auxiliary channel is assigned to both a switch and an Auxiliary Lever,
the switch takes precedence over the Auxiliary Lever in all cases.

17.F-MODE cOpY (FLigHT MODE pROgRaMMing DaTa cOpY)

The Flight Mode Copy function allows you to copy the Flight Mode programming data from one Flight Mode to another Flight
Mode. This is convenient if you want to use two or more different Flight Modes on one model, but only need to change a few
Flight Mode programming values for the new Flight Mode. This allows you to use the Flight Mode programming data from the
first Flight Mode to use as a base to start fine-tuning the programming for the second Flight Mode.
You can only copy Flight Mode programming data from one Flight Mode to another Flight Mode within the same model.
To copy Flight Mode programming data from one model's Flight Mode to another model's Flight Mode, you must copy
the actual model programming data to the other model. For more information, see page 52.
Copying Flight Mode Data
1) Press the Navigation Pad 56 to highlight F-MODE COPY, then press
the ENTER key to display the F-MODE COPY menu. The cursor
will default to MASTER>NORMAL(N).
2) Press the F-MODE key to select the Flight Mode you would like to copy the Flight Mode programming data FROM (MASTER).
Select from NORMAL (N), FLOAT (1), LAUNCH (2), REFLEX (3), or LAND (4).
3) Press the Navigation Pad 6 to highlight SLAVE>NORMAL(N).
4) Press the F-MODE key to select the Flight Mode you would like to copy
the Flight Mode programming data TO (SLAVE). Select from NORMAL
(N), FLOAT (1), LAUNCH (2), REFLEX (3), LAND (4), or ALL.
Selecting ALL will copy the MASTER Flight Mode programming data to the remaining four Flight Modes.
It's not possible to copy the Flight Mode programming data from one Flight Mode to the same Flight Mode. If you attempt
to execute this, SAME F-MODE?? will be displayed and the process will not execute.
Page 152