AIRTRONICS SD-10G Operating Manual page 150

glid Flight Mode menu
1) Press the Navigation Pad 6 to highlight POINT>5.
2) Press the YES/+ or NO/- keys to choose which Point you would like to
set a Rate percentage value for.
POINT setting range is 1 through 9. Point 1 is at the low end of the
channel Curve and Point 9 is at the high end of the channel Curve. Point
5 is a the center of the channel Curve.
3) Press the Navigation Pad 6 to highlight RATE>0%.
4) Press the YES/+ or NO/- keys to set the desired Rate percentage value.
RATE setting range is -150% to 150%. POINT 1 default RATE percentage value is 0%, POINT 5 default RATE percentage
value is 0%, and POINT 9 default RATE percentage value is 0%. POINT 2, 3, 4, 6, 7, and 8 RATE values are INH (Inhibited).
The Rate percentage value is a ratio of Slave channel servo travel to Master channel servo travel. For example, if the Rate
percentage value is set to 10%, the Slave channel servo will travel 1/10th the amount that the Master channel servo travels.
As you change the Point and Rate percentage values, you can use the graph and I/O numbers to visualize the ratio
between control stick movement and servo travel throughout the entire deflection range.
Changing the Delay Percentage Value
Changing the Delay percentage value allows you to adjust the speed of the Slave channel servo when moved in the direction
of the Master channel control stick (or switch) when the Compensation Mixing function is Active. For example, if you program
Compensation Mixing to provide Camber to rudder mixing, the trailing edge will move down when the rudder moves right and
left. The Camber and Reflex can also be controlled separately using Auxiliary Lever (VR6). Setting a Delay percentage value will
cause the flap and aileron servos to slow down ONLY in the up and down directions when the when the rudder is moved right
and left. Servo speed in the right and left directions for roll control will be normal, unless you have programmed aileron Channel
Delay separately.
The Delay function does not affect when the servo starts to respond to control stick movement. The Delay affects only
the transit time of the servo.
1) Press the Navigation Pad 6 to highlight DELAY>0%, then press the
YES/+ or NO/- keys to change the Delay percentage value.
The Delay percentage value is not Point-dependent.
DELAY setting range is 0% to 100%. The default setting is 0%. When the Delay percentage value is increased, the Slave
servo transit time will be slowed down. At 0%, the Slave servo moves at its normal speed. At 100%, the Slave servo takes
approximately 15 seconds to move from neutral to 100% or -100% travel.
The Delay function will cause the Slave servo transit time to slow down not only from neutral to one End Point, but also
on the return from one End Point to neutral, unless the Master channel is assigned to a switch. If the Master channel is
assigned to a switch, the Delay function will only affect the Slave servo in the neutral to End Point direction of travel. The Delay
function will not affect the Slave servo in the return to neutral direction of travel.
Page 150