AIRTRONICS SD-10G Operating Manual page 106

aero Flight Mode menu
Choosing the Slave Channel
The Slave channel is the channel that is controlled by the Master channel. For example if you set the Master channel to
EL (Elevator) and the Slave channel to AI (Aileron), when you move the elevator control stick, the ailerons will move. Depending
on the Model Type and Model Type selection options you've chosen in the Model Type menu, the following Slave channels
are available.
ABBR. FUNCTION
EL Elevator
Aileron
AI
TH Throttle
RU Rudder
GE Gear
FL Flap
1) Press the Navigation Pad 6 to highlight SLAVE>AI, then press the
YES/+ or NO/- keys to choose which channel you want to program the
Slave channel for.
The channel options displayed will vary based on Model Type and
Model Type selection options currently selected. For example, if your
model features dual aileron servos, LA and RA will be separate options.
Changing the Channel Curve Point Values and the Rate Percentage Values
Nine different Points with varying Rates can be programmed onto the channel Curve. Each Point will be displayed on the graph
to give you a visual interpretation of the position of the Point on the channel Curve. The Point that is currently selected will blink.
WARNING When a Compensation Mixer is Activated, you still have separate control over the Slaved channel, however,
depending on the Rate percentage value, the Slave channel End Point Adjustment could be exceeded. We strongly recommend
that you set your Slave channel Limits no higher than that channel's End Point Adjustment unless specifically necessary for
your particular setup. This will prevent any chance of overdriving your control linkage when Compensation Mixing is used.
1) Press the Navigation Pad 6 to highlight POINT>5.
2) Press the YES/+ or NO/- keys to choose which Point you would like to
set a Rate percentage value for.
POINT setting range is 1 through 9. Point 1 is at the low end of the
channel Curve and Point 9 is at the high end of the channel Curve. Point
5 is a the center of the channel Curve.
3) Press the Navigation Pad 6 to highlight RATE>0%.
4) Press the YES/+ or NO/- keys to set the desired Rate percentage value.
RATE setting range is -150% to 150%. POINT 1 default RATE percentage
value is 0%, POINT 5 default RATE percentage value is 0%, and POINT
9 default RATE percentage value is 0%. POINT 2, 3, 4, 6, 7, and 8 RATE
values are INH (Inhibited).
ABBR. FUNCTION
AUX1 Auxiliary 1
Auxiliary 2
AUX2
AUX3 Auxiliary 3
AUX4 Auxiliary 4
LE Left Elevator
RE Right Elevator
Page 106
ABBR. FUNCTION
LA Left Aileron
Right Aileron
RA
LT Left Throttle
RT Right Throttle
LF Left Flap
RF Right Flap