Flight Mode - AIRTRONICS SD-10G AERO Quick Start Manual

FLIGHT MODE 4

GEAR
Throttle Cut
Flap 1
Flap 2
EL > FL
FL > EL
C-MIX 1
C-MIX 2
C-MIX 3
C-MIX 4
C-MIX 5
Press the END key twice.
NOTE:
Turn OFF each Flight Mode switch after completion of programming each function and Mix.
All values show are trial values. Fine tune after completion of programming your setup.
FLIGHT MODE 1—Takeoff with Flaps in Down Position
Select SURFACE using the Navigation Pad. Press ENTER
Turn ON Flight Mode 1 Switch (#11)
Press Navigation Pad Down arrow and select EPA. Scroll to the right and select the LF
Use the YES/+ key to input a value of 50%. Do the same for the RF.
The screen will show 1 50% indicating that FLAP 1 is used for this function. Note that polarity
determines the direction of servo throw and value the amount........... Press END key twice.
Select F-MODE. Press ENTER
Turn ON Flight Mode 2 Switch (#10)
Scroll down to MIXING. Press ENTER
Scroll down to EL > FL. Press ENTER
Use the Navigation Pad and the YES/+ and NO/- keys to make it read:
Press the END Key twice.
>22 >or >--
>-- >or >--
>34 > or >--
>11 >or >--
>22> or >--
>10 >or >--
>22 >or >--
>23 >or >--
>23 >or >--
>22 >or >--
>22 >or >--
>--- >or > --
FLIGHT MODE 2 --- Elevator to Flap Mixing
F-MODE (2)
COMMON >SEP
EL >LF
EL >RF
- 2 -
> 20%
> 20%