Removing An Adapter Module - Nortel 114200-E Installation And Operating

Removing an Adapter Module

To remove a WAN adapter module:
1.
1
2
Figure 4-3.
2.
3.
4.
5.
114200-E Rev 00
Using a Phillips screwdriver, remove the screw that secures the adapter
module you want to remove
ISDN
DSU/CSU
Removing the Adapter Module Screw
Pull the adapter module toward you to detach it from the base module
connector in the ARN chassis.
Grasp the adapter module's metal tab, or insert a thin tool (such as a flathead
screwdriver) in the slot on the tab.
Be prepared to apply some force, but stop pulling immediately when the
adapter module is free from the base module connector.
Slide the adapter module all the way out of the slot.
Place the adapter module in an antistatic bag.
Go to the next section,
Installing a WAN Adapter Module
(Figure 4-3).
ARN0033A
"Installing an Adapter Module."
4-5