Prerequisites; Installing The Mounting Brackets On The Chassis - Nortel Secure Router 4134 Quick Start Manual

Prerequisites

•
•
Procedure steps
Step
1
2
3
4
5

Installing the mounting brackets on the chassis

You must install the mounting brackets on the Secure Router 4134 before
installing the chassis in an equipment rack. You can mount the Secure
Router 4134 with either the front panel or the back panel facing the
operator. The following table shows the six possible mounting positions.
Copyright © 2007, 2008 Nortel Networks
.
CAUTION
ESD
To prevent damage from electrostatic discharge, always wear
an antistatic wrist strap connected to an electrostatic discharge
(ESD) jack when performing maintenance on this product.
Ensure that the wrist strap makes contact with your skin.
CAUTION
ACHTUNG
ESD
Um Schäden durch elektrostatische Entladung zu verhindern,
tragen Sie bei der Instandhaltung dieses Produkts immer
ein antistatisches Band am Handgelenk, das mit einer
ESD-Buchse verbunden ist. Stellen Sie sicher, dass das Band
am Handgelenk Kontakt zur Haut hat.
Ensure you have the power supply module for the Secure Router 4134.
Ensure you have a Phillips #2 screwdriver.
Action
Using a Phillips screwdriver, loosen the two screws that secure
the metal plate that covers the slot in which you want to install
the power supply unit.
Remove the cover plate.
Insert the power supply module in the power supply slot.
Push the power supply module gently, but firmly, to insert it fully
into the internal connection port.
When the power supply is fully inserted, the front of the power
supply module is flush with the rear panel of the router.
Secure the power supply in the chassis by tightening the two
retaining screws.
Nortel Secure Router 4134
NN47263-100 02.01 Standard
18 February 2008
Installing the mounting brackets on the chassis 31
--End--
Quick Start