Prerequisites; Installing The Mounting Brackets On The Chassis - Nortel Secure 4134 Quick Start Manual

Prerequisites

•
•
Procedure steps
Step
1
2
3
4
5

Installing the mounting brackets on the chassis

You must install the mounting brackets on the Secure Router 4134 before
installing the chassis in an equipment rack. You can mount the Secure
Router 4134 with either the front panel or the back panel facing the operator.
The following table shows the six possible mounting positions.
Copyright © 2007, Nortel Networks
.
CAUTION
ESD
To prevent damage from electrostatic discharge, always wear an
antistatic wrist strap connected to an electrostatic discharge (ESD)
jack when performing maintenance on a Secure Router 4134.
Ensure that the wrist strap makes contact with your skin.
Ensure you have the power supply module for the Secure Router 4134.
Ensure you have a Phillips #2 screwdriver.
Action
Using a Phillips screwdriver, loosen the two screws that secure
the metal plate that covers the slot in which you want to install the
power supply unit.
Remove the cover plate.
Insert the power supply module in the power supply slot.
Push the power supply module gently, but firmly, to insert it fully
into the internal connection port.
When the power supply is fully inserted, the front of the power supply
module is flush with the rear panel of the router.
Secure the power supply in the chassis by tightening the two
retaining screws.
Nortel Secure Router 4134
NN47263-100 01.01 Standard
10.0 16 July 2007
Installing the mounting brackets on the chassis 25
—End—
Quick Start