Information On Terms Of Use - SAKI BF-Sirius Manual

Specification/Customer Support

3 Information on Terms of Use

The use of software ("Software") installed in a PCB Inspection System ("Inspection System") which Saki
corporation ("Saki") provides to customer ("Customer") based on this Standard Specification is subject to
the following Terms of Use ("Terms"). Customer can use the Software when Customer agrees to Terms.
Article 1(Right of Use)
Saki grants Customer the non-exclusive and non-transferable right of use for Software under Terms.
2. Customer may use Software only for Inspection System.
Article 2 (Copyrights)
Copyrights of Software shall be owned by Saki.
Article 3 (License key)
Saki shall make free exchange with replacement in principle if any trouble or failure should occur in
license key under normal use of Customer only when it is during the warranty period defined in the
Standard Specification. In case the free exchange with replacement is made, Customer agrees for the
license key with trouble or failure to be withdrawn by Saki.
2. If the events defined in following each paragraph should occur, Saki shall make nonfree exchange
even when it is during the warranty period defined in the Standard Specification, and shall present to
Customer the possibility of making nonfree exchange and the cost thereof at the direction of Saki.
(1) Failure and damage caused by acts of providence such as fires, earthquakes, lightning strikes,
wind and flood damages, gas damages, salt damages, and the like, or by external factors such as
connected equipment abnormalities and computer viruses.
(2) Failure and damage caused by inadequate repair, conversion, connection, and the like made by
Customer or intentional breakage.
(3) Failure and damage caused by inadequate use by Customer such as transportation, moving and
dropping after delivery.
(4) Loss after delivery and the like.
Article 4 (Installation Condition)
Customer shall always adjust and maintain the installation location of Inspection System to meet the
specifications specified by Saki or the installation condition defined in instructions for handling (e.g.
power sources, temperature, humidity, vibrations, magnetisms, saltiness, grounding conditions, etc.).
Article 5 (Prohibited Activities)
Customer shall not make any activities defined in following each paragraph.
(1) To rent, lease, transfer or re-license Software to any third party without permission from Saki.
(2) To reverse engineer, disassemble or decompile some or all of Software.
(3) To copy or tamper some or all of Software other than the purpose of making a backup of the
inspection environment.
(4) To make software and derivation similar to Software.
(5) To have any third party make activities defined in each previous paragraph.
Article 6(Indemnities)
If the events defined in following each paragraph should occur, Saki shall be released from the duty of
compensating any damages occurring on Customer by each event, or any and all other duties.
(1) In the event that Customer should make the prohibited activities defined in the previous Article.
BF-Sirius
IV-6