Loading / Unloading A Pcb; Guide Width Adjustment Method; Pcb Loading / Unloading Method - SAKI BF-Sirius Manual

3.5 Loading / Unloading a PCB

3.5.1 Guide Width Adjustment Method

The below operation needs to be done when you inspect the different size of PCBs.
Step1: Loosen the clamp lever.
Step2: Put the PCB close against front side of the guide rail.
Step3: Adjust the rail width and fix the clamp lever.
CAUTION

3.5.2 PCB Loading / Unloading Method

Put the PCB close against front side of the guide rail and carefully put the other side of the PCB on
the back side of the guide rail. Position the PCB leaning the PCB to the stopper on the right side and
also to the guide rail to the front side.
Clamp Lever
Sub Backup Pin
FFFure 3-24
When you inspect large PCB, support PCB using sub backup pin. Sub backup pin
set position without components.
Clamp Lever
Operation Manual
BF-Sirius
I-17