Error / Warning Message - SAKI BF-Sirius Manual

Maintenance Manual

4.2 Error / Warning Message

This section describes error / warning messages and the recovery methods.
Error and warning messages are displayed if the software cannot make judgements and human intervention
is required when selecting the inspection data and starting or quitting the inspection software.
In the table below, the contents of error and warning messages, and the action needs to be taken then are
listed.
Error / Warning Message
Release the Emergency switch and push the Reset
switch.
The servo motor is off. Do you want to continue?
GetImageStatus is failed.
EMERGENCY button is pushed.
Luminance adjustment was failed.
Luminance adjustment count was over the Limit.
BF-Sirius
II-24
Table 4-2 Error / Warning Messages and Recovery Methods
Description and Recovery Method
A reset confirmation dialog from the emergency stop
condition. Push the reset switch after releasing the
emergency stop condition.
The software can not complete the shading process.
Please perform the ALC tuning again. If the shading can
not be ended even if this procedure is repeated, contact
Saki Corporation.