SAKI BF-Sirius Manual page 4

Manual
CAUTION
WARNING
1
WARNING
2
BF-Sirius
This machine is the Inspection System for Printed Circuit Boards. Do not put objects other
than a PCB on the scan table it may result in malfunction.
Do not put the machine on a place with much vibration or shock.
Also, do not put it on an unstable place like a shaky table and a leaning place.
Objects should not be placed on the system. Objects falling off the system can cause
accidents. Such objects can also damage the system exterior and affect the system's
inspection performance.
To avoid system malfunction or accidents, operations not described in the operating
instructions should not be performed. Any problem caused by action in violation of the
above item is not covered by the warranty.
In case of lifting this machine, please support firmly by the equipment sole plate.
There is no intensity which can be equal to carrying in a cover.
Before undertaking any replacement of parts or maintenance servicing, ensure safety by
performing the following procedures:
・To avoid electric shock, turn off the circuit breaker.
・To avoid burns or injury, let the electric components and units cool down sufficiently.
Do not put a hand or any object in the driven section during the machine running.
It may result in personal injury.
To avoid malfunction or accidents, do not touch any system internal structure with the
exception of components described in this manual.
Connect the ground lead (to prevent electric shock in the event of current leakage) of the
power plug to one of the following items.
・Ground terminal of power outlet
・Installed (Type A - D) ground terminal
・Pipe permitted as the grounded object by waterworks department
With the power supply turned on, please do not move the main machine.
It may result in electric shock or personal injury.
To avoid electric shock, do not touch the power supply cord with a wet hand.
1.
Front View
Injury can result if fingers or hands are caught between the scan
table and base or between the motor and ball screw.
Although area sensor is operated as assist device for safety, do not
touch the unit when the machine is running. Be sure to turn off the
earth leakage breaker before servicing the unit.
Voltage hazard. Risk of electric shock.
Unplug the power supply cord before opening the cover.
2.
Rear View