Type C: Fiberoptic Sensor Amplifier; Maintenance Parts - SAKI BF-Sirius Manual

Maintenance Manual

2.1.3 Type C: Fiberoptic Sensor Amplifier

Step1: Initialize settings. Open the cover, hold down the
three seconds or more and push the MODE. Push either the Manual Button to display
on Current Value. Push the MODE to display
NOTE
Step2: Change the
PRESET of fiberoptic sensor amplifier. The PST lights green, the Current Value set 100.0
and the Setting Value set 50.0. Push up of the Manual Button, change the Setting Value
from 50.0 to 80.0.
Step3: Close the cover.
Manual Button (Up
PST
SET Setting Value
FFFure 2-2

2.2 Maintenance Parts

Table 2-4 shows parts that need to be replaced and approximate time for replacement.
NOTE
NOTE
Used Point
LED Lighting
Lighting-related
Shading Sheet [SJ10OP800]
Scan Table Spring [SJMC4B007]
Hard Disk Drive
PC-related
PC Power Supply
DC 5V Power Supply [SJEC1P005]
DC 12V Power Supply [SJEC1P004]
DC Power
Supply
DC 24V Power Supply [SJEC1P014]
DC 5V/24V Multi Power Supply [SJEC1P013]
BF-Sirius
II-14
After the settings are Initialized, the function are set to as shown in Table 2-3.
Setting Value. When no workpiece exists between fiberoptic sensors, push the
Down)
Current Value Power Mode Switch
(Light Intensity) (Set to the SEL)
Fiberoptic Sensor Amplifier
The replacement period depends on the usage environment and condition.
If you require to purchase maintenance parts, please contact Saki Corporation.
Item
Table 2-4
SET and the PRESET simultaneously for
PRESET
Power Mode
Sensitivity Setting Method
Detection Mode
Timer Function
MODE
APC Function
Eco Function
Table 2-3
Number of Scans
4 million times
Maintenance Parts List
and initialization is completed.
Function
D/L
Fiberoptic Sensor Amplifier
Replacement
Indication (Year)
SettFnF
L-on
FINE
Std
Std
OFF
OFF
OFF
SettFnFs
4
1
2
3
5