SAKI BF-Sirius Manual page 31

Step3: If inspection result is OK, the dialog shown in Figure 3-36 appears. Press
load the PCB. Push the start switch to start the next inspection.
If inspection result is NG, the dialog shown in Figure 3-37 appears.
Each item is described in Table 3-4 and 3-5.
NOTE
B
C
(A) Upper Right Image
(B) Upper Left Image
By comparing these two images, (A) and (B) with the actual PCB, determine a good PCB
vs. a defective PCB, and whether the defect is a false or not.
OK
Press if the PCB that result will be OK.
REPAIR Press if the PCB that result will be NG.
FFFure 3-36 In Case that Inspection Result is OK
It enables to start scanning next PCB while judging the result.
FFFure 3-37 Edit NG Component Data
Show the point that the result will be NG.
Show the position of upper right image using yellow lines.
Operation Manual
OK and unload /
A
D
BF-Sirius
I-25