3.2 System Activation
This section describes the procedures for the system startup.
Separate switches are used for the system activation of the inspection machine and the PC.
3.2.1 System Pre-boot Check
Check the following items before turn on the power.
If any problem occurs, please contact Saki Corporation or our representatives.
•
There is no deep external scratch on the inspection machine.
•
There is no damage in the power supply cords and connection cables.
•
All power supply cords and connection cables are connected firmly and correctly.
•
There is no object on the scan table.
•
There is no object which hinders table-motion.
•
There is no object on the machine.
•
There is no foreign object inserted in the entrance of the machine.
3.2.2 Turn on the Machine
Step1:
Turn on the earth leakage breaker on the rear side of the machine and turn the main breaker
clockwise direction to power on the machine.
Step2:
Beep tones sound after turn on the power and push the reset switch.
As the machine activates normally, the power lamp lights on.
Main Breaker
Reset Switch
Power Lamp
FFFure 3-5
Turn on the Machine
Operation Manual
Earth Leakage Breaker
BF-Sirius
I-9