Operation Manual
3.8 Manual Mode
3.8.1 Operation Procedure of Manual Mode
In Manual Mode, all operations are done by an operator.
All operations are required by manually clicking on the menu-bar except for the result output.
Step
Process
1
Loading the PCB
2
Scanning
3
Inspection
4
Result output
5
Unloading the PCB
3.8.2 Inspection Method of Manual Mode
Step1:
Select a data according to
Step2:
Put a PCB to inspect on the scan table.
Step3:
Press
Step4:
After the PCB image is displayed on the window, check the image display for distortion or
tilt. If the image is distorted or tilted, please contact Saki Corporation.
Step5:
Press
Step6:
Inspection result is displayed in the upper side of the index flame. If the inspection result is
OK, OK is displayed in green. If defect is detected, NG is displayed in red.
Step7:
Unload the PCB in the machine.
BF-Sirius
I-20
FFFure 3-28
Load the PCB manually.
Press Scan button on the tool-bar or select Scan from the menu-bar.
Press Inspect button on the tool-bar or select Inspect from the menu-bar.
Unload the PCB manually.
Table 3-1
Operation Procedure in Manual Mode
3.4 Select Inspection Data.
Scan button on the tool-bar or select Scan from the menu-bar.
Inspect button on the tool-bar or select Inspect from the menu-bar.
Scan, Inspect
Manual Mode
↓