Time Zone Settings - D-Link DGS-3200 Series User Manual

Time Zone Settings

The following window is used to configure time zones and Daylight Savings time settings for SNTP. Open the Configuration
folder, click SNTP Settings, and click the Time Zone Settings link, revealing the following window.
The following parameters can be set:
Parameter
Daylight Saving Time State
Daylight Saving Time Offset In Minutes
Time Zone Offset From GMT In +/- HH:MM
DST Repeating Settings - Using repeating mode will enable DST seasonal time adjustment. Repeating mode
requires that the DST beginning and ending date be specified using a formula. For example, specify to begin DST on
Saturday during the second week of April and end DST on Sunday during the last week of October.
From: Which Week Of The Month
From: Day Of Week
From: Month
From: Time In HH:MM
To: Which Day
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6- 32. Time Zone Settings window
Description
Use this pull-down menu to enable or disable the DST Settings.
Use this pull-down menu to specify the amount of time that will
constitute your local DST offset - 30, 60, 90, or 120 minutes.
Use these pull-down menus to specify your local time zone's offset
from Greenwich Mean Time (GMT.)
Enter the week of the month that DST will start.
Enter the day of the week that DST will start on.
Enter the month DST will start on.
Enter the time of day that DST will start on.
Enter the week of the month the DST will end.
52