Installing The Sfp Ports - D-Link DGS-3200 Series User Manual

Installing the SFP ports

The Switch is equipped with SFP (Small Form Factor Portable) ports, which are to be used with fiber-optical transceiver cabling
in order to uplink various other networking devices for a gigabit link that may span great distances. These SFP ports support full-
duplex transmissions, have auto-negotiation and can be used with DEM-310GT (1000BASE-LX), DEM-311GT (1000BASE-SX),
DEM-312GT2 (1000BASE-SX), DEM-314GT (1000BASE-LH) and DEM-315GT (1000BASE-ZX) transceivers. See the figure
below for installing the SFP ports in the Switch. In addition, DEM-210 (Single Mode, 100BASE-FX) and DEM-211* (Multi
Mode, 100BASE-FX) SFP transceivers are supported. WDM transceivers supported include DEM-330T (TX-1550/RX-1310nm),
DEM-330R (TX-1310/RX-1550nm), DEM-331T (TX-1550/RX-1310nm), and DEM-331R (TX1310/RX-1550).
Figure 2- 7. Inserting the fiber-optic transceivers into the DGS-3200-10
Figure 2- 8. Inserting the fiber-optic transceivers into the DGS-3200-16
NOTE: *The fiber-optic transceiver module DEM-211 may fail to link when inserted into
the SFP ports if the two combo copper ports are both in linking status. The solution to this
limitation is to remove the combo copper cable before using this module. Only module
DEM-211 has this limitation.
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
11