Ping Test - D-Link DGS-3200 Series User Manual

Ping Test

Ping is a small program that sends ICMP Echo packets to the IP address you specify. The destination node then responds to or
"echoes" the packets sent from the Switch. This is very useful to verify connectivity between the Switch and other nodes on the
network.
The following window is used to Ping either an IPv4 address or an IPv6 address. To locate this window, open the Configuration
folder and click Ping Test.
The user may click the Infinite times radio button, in the Repeat Pinging for field, which will tell the ping program to keep
sending ICMP Echo packets to the specified IP address until the program is stopped. The user may opt to choose a specific
number of times to ping the Target IP Address by clicking its radio button and entering a number between 1 and 255. Click Start
to initiate the Ping program.
The following parameters may be configured or viewed:
Parameter Description
Target IP Enter an IP address to be Pinged.
Address
For IPv6 only, enter the name of the interface to be Pinged.
Interface Name
Enter the number of times desired to attempt to Ping either the IPv4 address or the IPv6 address
Repeat Pinging
for configured in this window. Users may enter a number of times between 1 and 255.
Size For IPv6 only, enter a value between 1 and 6000. The default is 100.
Timeout For IPv4, select a timeout period between 1 and 99 seconds for this Ping message to reach its
destination. For IPv6, select a timeout period between 1 and 10 seconds for this Ping message
to reach its destination. In either case, if the packet fails to find the IP address in this specified
time, the Ping packet will be dropped.
Click Start to initialize the Ping program.
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6- 30. Ping Test window
50