Snmp Host Table; Snmp V6Host Table - D-Link DGS-3200 Series User Manual

SNMP Host Table

Use the SNMP Host Table window to set up SNMP trap recipients. Open the SNMP Settings folder located in the
Configuration folder and click on the SNMP Host Table link. This will open the SNMP Host Table window, as shown below.
To delete an existing SNMP Host Table entry, click the Delete button corresponding to the entry to delete.
To add a new entry to the Switch's SNMP Host Table, enter the information at the top of the window and then click the Apply
button.
The following parameters can set:
Parameter
Host IP Address
SNMP Version
Community String /
SNMP V3 User Name
To implement your new settings, click Apply.

SNMP v6Host Table

Use the SNMP v6Host Table window to set up SNMP trap recipients. Open the SNMP Settings folder located in the
Configuration folder and click on the SNMP v6Host Table link. This will open the SNMP v6Host Table window, as shown
below. To delete an existing SNMP v6Host Table entry, click the Delete button corresponding to the entry to delete.
To add a new entry to the Switch's SNMP v6Host Table, enter the information at the top of the window and then click the Apply
button.
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6- 40. SNMP Host Table window
Description
Type the IP address of the remote management station that will serve as the SNMP host for
the Switch.
V1 - To specifies that SNMP version 1 will be used.
V2c - To specify that SNMP version 2c will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with an Auth-Priv security
level.
Type in the community string or SNMP V3 user name as appropriate.
Figure 6- 41. SNMP v6Host Table window
60