Ip-Mac Binding Blocked - D-Link DGS-3200 Series User Manual

All Ports
NOTE: When configuring the ACL mode function of the IP-MAC binding function, please pay
close attention to previously set ACL entries. Since the ACL mode entries will fill the first two
available access profiles and access profile IDs denote the ACL priority, the ACL mode entries
may take precedence over other configured ACL entries. This may render some user-defined
ACL parameters inoperable due to the overlapping of settings combined with the ACL entry
priority (defined by profile ID). For more information on ACL settings, please see the next
chapter.
NOTE: Once ACL profiles have been created by the Switch through the IP-MAC binding
function, the user cannot modify, delete, or add ACL rules to these ACL mode access profile
entries. Any attempt to modify, delete, or add ACL rules will result in a configuration error.
NOTE: When uploading configuration files to the Switch, be aware of the ACL configurations
loaded, as compared to the ACL mode access profile entries set by this function, which may
cause both access profile types to experience problems.

IP-MAC Binding Blocked

This window allows users to view unauthorized devices that have been blocked by IP-MAC binding restrictions.
To open the IP-MAC Binding Blocked window shown below, click Security > IP-MAC Port Binding > IP-MAC Binding
Blocked.
To find an unauthorized device that has been blocked by the IP-MAC binding restrictions, enter the VLAN name and MAC
Address in the appropriate fields and click Find. To delete an entry click the Delete button corresponding to the entry's MAC
address on the table at the bottom of the window. To delete all the entries on the table, click Clear All.
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Tick this check box to configure this IP-MAC binding entry (IP Address + MAC Address) for all
ports on the Switch.
Figure 9- 6. IP-MAC Binding Blocked window
118