Dhcp/Bootp Relay Interface Settings; Dhcp Auto Configuration Settings - D-Link DGS-3200 Series User Manual

DHCP/BOOTP Relay Interface Settings

This window allows the user to set up a server, by IP address, for relaying DHCP/BOOTP information to the Switch. The user
may enter a previously configured IP interface on the Switch that will be connected directly to the DHCP/BOOTP server using
this window. Properly configured settings will be displayed in the DHCP/BOOTP Relay Interface Table at the bottom of the
window, once the user clicks the Apply button. The user may add up to four server IPs per IP interface on the Switch. Entries may
be deleted by clicking the corresponding Delete button.
To enable and configure DHCP/BOOTP Relay Global Settings on the Switch, click Configuration > DHCP/BOOTP Relay >
DHCP/BOOTP Relay Interface Settings:
The following parameters may be configured or viewed:
Parameter Description
Interface The IP interface on the Switch that will be connected directly to the Server.
Server IP Enter the IP address of the DHCP/BOOTP server. Up to four server IPs can be configured per IP
Interface.
Click Apply to include this Server IP.

DHCP Auto Configuration Settings

This window is used to enable the DHCP auto configuration feature on the Switch. When enabled, the Switch is instructed to
receive a configuration file from a TFTP server, which will set the Switch to become a DHCP client automatically on boot-up. To
employ this method, the DHCP server must be set up to deliver the TFTP server IP address and configuration file name
information in the DHCP reply packet. The TFTP server must be up and running and hold the necessary configuration file stored
in its base directory when the request is received from the Switch. For more information about loading a configuration file for use
by a client, see the DHCP server and/or TFTP server software instructions. The user may also consult the Upload Log File
window description located in the Tools section of this manual.
If the Switch is unable to complete the DHCP auto configuration, the previously saved configuration file present in the Switch's
memory will be used.
To enable and configure DHCP auto configuration settings on the Switch, click Configuration > DHCP Auto Configuration
Settings:
To enable the DHCP Auto Configuration State, use the pull-down menu to choose Enabled and click the Apply button.
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6- 20. DHCP/BOOTP Relay Interface Settings window
Figure 6- 21. DHCP Auto Configuration Settings window
43