Jwac Port Settings - D-Link DGS-3200 Series User Manual

JWAC Port Settings

To configure JWAC port settings for the Switch, go to the Security folder, open JWAC, and click JWAC Port Settings, which
will open the following window:
To set the JWAC on individual ports for the Switch, complete the following fields:
Parameter
From Port
To Port
Aging Time (1-1440)
MAC Authenticating
Host (1-10)
Idle Time (1-1440)
Block Time (0-300)
State
Click Apply to implement changes made.
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 9- 36. JWAC Port Settings window
Description
Use this drop-down menu to select the beginning port of a range of ports to be enabled as
JWAC ports.
Use this drop-down menu to select the ending port of a range of ports to be enabled as
JWAC ports.
This parameter specifies the time period during which an authenticated host will remain in the
authenticated state. Enter a value between 0 and 1440 minutes. A value of 0 indicates the
authenticated host will never age out on the port.
This parameter specifies the maximum number of host process authentication attempts
allowed on each port at the same time. Enter a value between 1 and 10 attempts.
If there is no traffic during the Idle Time parameter, the host will be moved back to the
unauthenticated state. Enter a value between 0 and 1440 minutes. A value of 0 indicates the
Idle state of the authenticated host on the port will never be checked.
This parameter is the period of time a host will be blocked if it fails to pass authentication.
Enter a value between 0 and 300 seconds.
Use this drop-down menu to enable the configured ports as JWAC ports.
149