D-Link DGS-3200 Series User Manual page 170

To view the setting details for a created profile, click the Show Details button for the corresponding entry on the Access Profile
List window, revealing the following window:
The window shown below is the Add ACL Profile window for Packet Content:
The following parameters can be set for the Packet Content type:
Parameter
Select Profile ID
Select ACL Type
Packet Content
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 10- 7. Access Profile Detail Information window for IPv6
Figure 10- 8. Add ACL Profile window for Packet Content
Description
Use the drop-down menu to select a unique identifier number for this profile set. This value
can be set from 1 to 200.
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or packet
content. This will change the window according to the requirements for the type of profile.
Select Ethernet ACL to instruct the Switch to examine the layer 2 part of each packet header.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each frame's header.
Select IPv6 ACL to instruct the Switch to examine the IPv6 address in each frame's header.
Select Packet Content to instruct the Switch to examine the packet content in each frame's
header.
Allows users to examine up to four specified offset chunks within a packet, one at a time. A
chunk mask presents four bytes. Four offset chunks can be selected from a possible 32
156