D-Link DGS-3200 Series User Manual page 107

To configure the settings for MLD snooping, click L2 Features > MLD Snooping Settings, which will open the following
window.
This window displays the current MLD Snooping settings set on the Switch, defined by VLAN. To configure a specific VLAN for
MLD snooping, click the VLAN's corresponding Edit button.
The following parameters may be viewed or modified:
Parameter
VID
VLAN Name
Done Timer
Node Timeout
Router Timeout
State
Click Apply to implement changes made.
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 7- 23. MLD Snooping Settings window
Description
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN for which
to modify the MLD Snooping Settings.
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN for which
to modify the MLD Snooping Settings.
Specifies the maximum amount of time a router can remain in the Switch after
receiving a done message from the group without receiving a node listener report.
The user may specify a time between 1 and 16711450 with a default setting of 2
seconds.
Specifies the link node timeout, in seconds. After this timer expires, this node will no
longer be considered as listening node. The user may specify a time between 1 and
16711450 with a default setting of 260 seconds.
Specifies the maximum amount of time a router can remain in the Switch's routing
table as a listening node of a multicast group without the Switch receiving a node
listener report. The user may specify a time between 1 and 16711450 with a default
setting of 260 seconds.
Used to enable or disable MLD snooping for the specified VLAN. This field is
Disabled by default.
93