D-Link DGS-3200 Series User Manual page 167

Figure 10- 3. Access Profile Detail Information window for Ethernet
The window shown below is the Add ACL Profile window for IPv4:
The following parameters can be set for the IPv4 ACL type:
Parameter
Select Profile ID
Select ACL Type
802.1Q VLAN
IPv4 DSCP
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 10- 4. Add ACL Profile window for IPv4 ACL
Description
Use the drop-down menu to select a unique identifier number for this profile set. This value
can be set from 1 to 200.
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or packet
content. This will change the window according to the requirements for the type of profile.
Select Ethernet ACL to instruct the Switch to examine the layer 2 part of each packet header.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each frame's header.
Select IPv6 ACL to instruct the Switch to examine the IPv6 address in each frame's header.
Select Packet Content to instruct the Switch to examine the packet content in each frame's
header.
Selecting this option instructs the Switch to examine the 802.1Q VLAN identifier of each
packet header and use this as the full or partial criterion for forwarding.
Selecting this option instructs the Switch to examine the DiffServ Code part of each packet
header and use this as the, or part of the criterion for forwarding.
153