Cli Paging Settings; Firmware Information - D-Link DGS-3200 Series User Manual

CLI Paging Settings

To configure CLI paging on the Switch, click Configuration > CLI Paging Settings:
The following parameter may be configured or viewed:
Parameter Description
CLI Paging Command Line Interface paging stops each page at the end of the console. This allows you to
Status stop the scrolling of multiple page of text beyond the limits of the console. CLI Paging is Enabled
by default. To disable it, click the Disabled radio button.
Click Apply to set the CLI Paging setting.

Firmware Information

This window allows the user to view, set the next boot-up status, and delete current firmware images stored on the Switch. To set
firmware as the boot-up firmware the next time the Switch is restarted, click the Set Boot button. To remove the firmware from
this window, click the Delete button.
To access the following window, click Configuration > Firmware Information.
The following parameters may be configured or viewed:
Parameter Description
ID States the image ID number of the firmware in the Switch's memory. The Switch can store 2
firmware images for use. Image ID 1 will be the default boot-up firmware for the Switch unless
otherwise configured by the user.
Version States the firmware version.
Size States the size of the corresponding firmware, in bytes.
Update Time States the specific time the firmware version was downloaded to the Switch.
From States the IP address of the origin of the firmware. There are five ways firmware may be
downloaded to the Switch. Boot-up files are denoted by an asterisk (*) next to the file.
R – If the IP address has this letter attached to it, it denotes a firmware upgrade through the
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6- 26. CLI Paging Settings window
Figure 6- 27. Firmware Information window
46