Table of Contents
Advertisement
4.4
Installing the handwheel
Note
The handwheel and all parts for the assembly can be found in the carton with the accessories.
The handwheel can be dismounted for transporting (e.g. narrow doors).
Fig. 9
To install the handwheel, follow these steps:
1. Insert the pin
handwheel.
2. Attach the spring washer
3. Tighten the screw
4. Attach the cover disk (self-adhesive - not pictured).
» To deinstall, proceed in reverse order.
Warning
Rotate the handwheel only if the cryostat is cooled and the cryochamber is cold.
Leica CM1520
1
2
(→ "Fig. 9-1")
of the handwheel shaft into the hole
(→ "Fig. 9-3")
(→ "Fig. 9-4")
using the Allen key (6 mm).
Installing the Instrument
3
to the screw as shown in
4
(→ "Fig. 9-2")
of the
(→ "Fig. 9")
(→ "Fig. 9-4").
4
25
Advertisement
Table of Contents
