Table of Contents
Advertisement
Inserting knife holder CN
3. Push the knife holder
place on the left side using an Allen key (No. 4) (→ "Fig. 43-23").
23
Fig. 43
Note
Clearance angle settings between 4° - 6° for the knife holder CN and 2° - 5° for the blade holder CE, CE-
TC and premium blade holder are suitable for most applications.
Inserting/removing the knife
Note
The height of resharpened knives must be adjusted using the knurled screws
1 mm under the edge of the clamping jaw).
Make sure that the knife is parallel from one end to the other.
Warning
The safety gloves included in the
inserting/removing the knife!
• Insert the knife backrest
the notch
(→ "Fig. 44-24")
lower position is reached.
• The knife can now be inserted from the side and its height adjusted using the knurled screws
(→ "Fig. 44-4"). The upper edge of the rear clamping jaw serves as an index point for the correct
knife height. The height of the knife blade should match that of the rear clamping jaws. This makes it
possible to accurately adjust even frequently resharpened knives up to a height of 25 mm.
• Once the correct height is obtained, tighten the wingscrews
both are tight.
Leica CM1520
(→ "Fig. 43-3")
onto the
1
(→ P. 24 – 4.3 Standard delivery - packing list)
(→ "Fig. 44-3")
on the side above the knurled screw
faces the user – turn the knurled screws for height adjustment until the
Daily Use of the Instrument
(→ "Fig. 43-1")
base. Clamp the knife holder into
3
(→ "Fig. 44-7")
(→ "Fig. 44-4")
(approx.
must be worn when
(→ "Fig. 44-4")
so that
in alternating order until
7
49
Advertisement
Table of Contents
