Siemens SINUMERIK 840 Planning Manual page 76

02.93
Routing the identifier bits
Identifier in dynamic buffer
R 38 (8 bit) R 21 (8 bit)
R 40 (8 bit) R 39 (8 bit)
Behavior on occurrence of an error
All errors are output as messages by NC cycle L947, unless a RESET is carried out or a
power failure occurs. NC cycle L947 then goes into programmed "STOP". If NC START is
carried out, the NC cycle again goes onto programmed STOP.
Block data
Lib. No. : E8830-B5520-A
FBs to be loaded : FB111, FB120, FB132, FB138, FB139
DBs to be loaded : None
Type of FB call : Unconditional
DBs to be input : None
Error messages : %30: M function entered by user in MD2069 is not in the range 1 to
: %31: The entered M function was called again before the previous
Option which must be set: Option for file handling commands
Error messages which lead to job abort
Data: DD230 data block: DB135
– 16 Illegal function code
The function code does not lie between 0 and 3
– 17 Transmission error PLC NC
An error occurred on transmission of tool data into the R parameters with
FB62
– 37 Unloading cycle L947 and loading cycle L940 are active at the same time
– 41 Magazine end smaller than magazine start
– 51 to 74 are data distributor error numbers. See documentation FB139.
Subtract from the given F no. 50 to arrive at the exact F no. of the
data distributor.
_______
*)
Please notify Service if not available.
© Siemens AG 1991 All Rights Reserved
SINUMERIK 840/880 (PJ)
9999
call was concluded
6FC5 197-0AA40-1BP1
5 Configuring
5.5 FB 120 Unloading via tape
*)
5–15