Siemens SINUMERIK 840 Planning Manual page 112

01.91
5: Resetting the "Tool already entered" bits for all tools in the specified magazine.
Bit 0 in DB 153 of the specified magazine area
Specification: Magazine No.
6: Setting the identification bits set at the interface in the magazine table (DB 152).
Specification: Magazine No., locator No.
7: Clearing the identification bits set at the interface in the magazine table (DB 152).
Specification: Magazine No., locator No.
8: Clearing magazine location
The decision whether the ID and Duplo No. remain unchanged is made by the subroutine
"SR: KC 8+9", depending on whether retrofitting was selected.
Specification: Magazine No.
Locator No. which is to be deleted
9: Clearing magazine
The decision whether the ID and Duplo No. remain unchanged is made by the subroutine
"SR: KC 8+9", depending on whether reloading was selected.
Specification: Magazine No.
Locator number starting from which the data are to be deleted in
ascending order.
10: Enabling tool
Identification bit 8 "Do not enable tool" is reset (with or without loading with operator
guidance).
Specification: Magazine No., locator No.
If locator No. = 0, the tool is searched for according to the T and Duplo
Nos. and subsequently enabled.
Block data
Lib. No.
FBs to be loaded
DBs to be loaded
Type of FB call
DBs to be input
Error messages
that cause a stop state
© Siemens AG 1991 All Rights Reserved
SINUMERIK 840/880 (PJ)
: E88530-B5539-A
: FB 127, FB 130, FB 139, FB 140, FB 141, FB 142, FB 143
FB 144
: None
: Unconditional
: None
: %1: TO configuration was changed and TO assignment
not empty
Restore old configuration and delete all magazine data
by means of command codes 8 and 9 of the data
distributor, or reset PLC.
6FC5 197-0AA40-1BP1
5 Configuring
5.13 FB 139 Data distributor
5–51