Siemens SINUMERIK 840 Planning Manual page 61

4 Installation and Start-up
PLC MD 7012.3 =
PLC MD 7013.7 =
PLC MD 7013.6 =
PLC MD 7013.4 =
PLC MD 7013.2 =
PLC MD 7013.0 =
PLC MD 7014.3 =
PLC MD 7015.7 =
PLC MD 7015.4 =
PLC MD 7015.2 =
PLC MD 7015.0 =
2. Transfer link list (FRBINDE 1 Var. B) to UMS.
3. The blocks of tool management package 1 are loaded from diskette into the PLC. FB 117
must be called in OB 20 to create the magazine table. In OB 1, FB 139 "Data distributor"
is called, which also generates DB 144 (required for the loading procedure). In addition,
FB 123 ("Tool selection on T change signal") must be called unconditionally in OB 1. If the
operating example is to be used, the relevant blocks must also be transferred to the PLC.
The operating example is called by FB 160 in OB 1.
Note:
The magazine table can only be extended by first deleting it and then creating it again.
4–2
1 Chain magazine
1 With single tool
1 Additional magazine assigned
1 Magazine is assigned to a buffer
1 Active magazine
1 Submagazine available
1 Chain magazine
1 With single tool
1 Magazine is assigned to a buffer
0 Background magazine (SINUMERIK 880/880 GA2 only)
1 Submagazine available
© Siemens AG 1991 All Rights Reserved
11.92
6FC5 197-0AA40-1BP1
SINUMERIK 840/880 (PJ)