Installation And Start-Up - Siemens SINUMERIK 840 Planning Manual

11.92
4

Installation and Start-up

The following instructions serve as a brief installation and start-up guide. A detailed guide is
envisaged.
Proceed as follows to install both the 880 tool management package and the operator
panel with tool data menu (milling example).
1. Enter machine data and format user memory, if necessary.
Relevant machine data:
(the default in the example applies to a machine with 2 magazines (1 active magazine,
1 background magazine), 1 TO area, 1 spindle)
NC MD 13 =
NC MD 210 =
NC MD 211 =
NC MD 1040 =
NC MD 5440.4 =
NC MD 5440.6 =
PLC MD 2000 =
PLC MD 2001 =
PLC MD 2002 =
PLC MD 2003 =
PLC MD 2004 =
PLC MD 2005 =
PLC MD 2006 =
PLC MD 2007 =
PLC MD 2008 =
PLC MD 2009 =
PLC MD 2010 =
PLC MD 2011 =
PLC MD 2068 =
PLC MD 2072 =
PLC MD 2075 =
PLC MD 2076 =
ˆ =
PLC MD 7010.7 =
–––––––––––––––
*) If the operating example is to be used without any modifications, these presettings are obligatory.
© Siemens AG 1991 All Rights Reserved
SINUMERIK 840/880 (PJ)
16 16 TO parameters
1 1 TO area
1 Initial D No. TO area 1
1 TO area 1 for channel 1
0 T word channel 1, binary output
0 H word channel 1, binary output
4 *) Initial address, buffer
10 Number of data words, buffer
7 Number of DBs for user
4 Number of DBs for reference data
31 Initial address magazine 1
10 Length of magazine
1 Assigned TO area
2 Assigned background magazine
(SINUMERIK 880/880 GA2 only)
41 Initial address magazine 2
10 Length of magazine
1 Assigned TO area
0 Assigned background magazine
(SINUMERIK 880/880 GA2 only)
70 M function for tape start
57 H group for special position
1 Number of magazines assigned to a tool buffer
KY = 1,4 *) Spindle No./absolute address of spindle in
KF = 260 tool buffer (conforms to DW No.)
1 Tool management software runs on PLC 1
6FC5 197-0AA40-1BP1
4 Installation and Start-up
4–1