Adjustment Of Front Feet; Connections In The Service Compartment; Hoses - Atmos S 61 Operating Instructions Manual

3.0 Setting up and starting up

3.9 Adjustment of front feet

3.10 Connections in the service compartment

3.10.1 Hoses

Insert phone jack into marked jack
Insert the three-hole gasket at the
inlet hose of the water connection for
ear irrigation.
) A „three-hole gasket" must be used
otherwise a malfunction of the
device could be the result!
First start-up
Prior to shipment each ATMOS
safe functioning of the device after transport and installation, the following points should be observed:
The user should only operate the device when
1. a functional test was carried out on the device at the place of operation.
2. the operating instructions were read and acknowledged.
After transportation/storage of the device at low temperatures and prior to first start-up it should be kept at room temperature for
at least four hours. If the device is not acclimatised the formation of condensation water is possible and a malfunction might be
the result.
Adjust the screws of the feet through the boreholes with a flat-bladed screwdriver scaled
4-5.
Insert application parts into the hanging
strip
Connect water hose in the service
compartment
Open the tap on the treatment unit.
Check whether all connections are
leakproof.
S 61 Servant was checked by the manufacturer for function and safety. In order to ensure the
®
Connect compressed-air hose
in the service compartment
13