Programming; Leg Rest Adjustment; Leg Rest (Ref 503.0552.0) - Atmos Chair 41 Gyne Operating Instructions Manual

Table of Contents

4.0 Operation

Warning:

When moving the chair make sure that the patient has her hands at the chair and that third persons and things are



in adequate distance from the chair.

4.2

Programming

Proceed as follows to program (keys "I","II" and "III" of the right-hand foot pedal):

1. Bring the chair into basic position by pressing the "0" key shortly.

2. Bring the chair into the requested position.

3. Keep depressed the programming switch M, which is on the "cover", on the left of the lifting mechanism and lightly

press key "I", "II" or "III" depending on the requested storage place.

4. An acoustic signal (beep) confirms successful saving.

4.3

Proceed as follows to move the leg rest:

Hold the patient's leg with one hand, loosen handle 1 and

adjust the height of the leg rest. When the required position is

reached, tighten handle 1 again.

To adjust the positionable leg rest 2, loosen handle 3, move the

leg rest to the required position and retighten handle 3.

4.4

For extracting the leg rest:

Catch the leg rest in centre between seat and secretion bowl.

Now pull out the leg rest until it is on the same level like the

seat.

When pulling the leg rest in:

ATTENTION! Do not touch the guiding rail of the leg rest

(see Fig. 4.3). There is a risk of injury!

Grasp the centre of the leg support. With the other hand

grasp the metal bar under the leg support and hold it tight.

Now slide the support back until it declines. As soon as the

leg support declines, take your hand from the metal bar and

slide the support backwards until it snaps in.

Fig 4.2

Fig 4.3

Table of Contents