Installing The Compression Card; Figure C-2. Removing The Model 8000 Rac Cover - Bay Networks 8000 RAC Installing Manual

Installing the Compression Card

Figure C-2. Removing the Model 8000 RAC Cover

Observe handling precautions for electrostatic-sensitive
devices.
To install the compression card on the main logic board
1. Find the location in which you plan to install the
compression card.
2. Orient the compression card and carefully press it into the
card connector
is fully seated.
3. Push the corners of the compression card down onto the
nylon standoffs until the locking tabs engage.
Installing the Model 8000 Remote Access Concentrator
Appendix C Data Compression Upgrade Instructions
(Figure C-3). Make sure that the connector
RA0022A
(Figure C-3):
C-3