Table of Contents
Advertisement
T
his manual describes how to install a Model 8000 Remote Access
Concentrator. For brevity, this manual often uses the acronym RAC to
refer to the Remote Access Concentrator.
Refer to Installing Remote Access Concentrator Software for UNIX or
Installing Remote Access Concentrator Software for Windows and
Windows NT
for a description of the software installation. Refer to
®
Managing Remote Access Concentrators Using Command Line
Interfaces for configuration information.
If you want
An overview of the Model 8000 Remote Access
Concentrator, including a description of the hardware
features and firmware functions
Instructions for installing the RAC and confirming its
operating status
A description the ROM Monitor commands that modify
specific configuration parameters, perform diagnostic tests,
and load the operational code
Troubleshooting and verification procedures
A description of the port connectors located on the RAC
Instructions for installing and removing modem cards on the
RAC main logic board
Instructions for installing the data compression card on the
RAC main logic board
Installing the Model 8000 Remote Access Concentrator
About This Guide
Go to
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Appendix A
Appendix B
Appendix C
xxiii
Advertisement
Table of Contents
