Connecting Wan Interfaces - Bay Networks 8000 RAC Installing Manual

Connecting WAN Interfaces

Chapter 2
The WAN Interfaces connect the RAC to channelized T1, channelized
E1, and ISDN PRI lines. To connect the lines to the WAN Interface ports:
1. Configure the WAN interface using any of these tools:
• The admin CLI command (refer to Managing Remote
Access Concentrators Using Command Line Interfaces
for details)
• Annex Manager (refer to Managing Remote Access
Concentrators Using Annex Manager for details)
• Quick2Config Annex (if you are using a PC; see the
online help for Quick2Config Annex for details)
The switch type and other WAN parameters must be configured
properly to be compatible with those provided by the telco. The
telco may disable lines connected to an improperly configured
device.
2. Plug the RJ-48C connectors located on the WAN interface
cable into the WAN interface ports located on the rear panel
of the RAC (see
Observe handling precautions for digital telecommunications
cables.
When the connector clicks into place, the connection is secure.
Appendix A describes WAN interface port signal/pin
allocations.
Installing the Model 8000 Remote Access Concentrator
Installing the Model 8000 Remote Access Concentrator
Figure 2-9).
2-13