Table of Contents
Advertisement
Appendix C
Data Compression Upgrade Instructions
Replacing the RAC Cover
Installing the Model 8000 Remote Access Concentrator
C-4
Figure C-3. Installing the Compression Card
To replace the RAC cover
1.
Lower the cover onto the unit at an angle, and insert the five
tabs on the cover into the corresponding slots on the chassis
(Figure
C-4).
2.
Swing the cover down into place, making sure the tabs on
the sides of the cover fit inside the corresponding slots in the
chassis.
3.
Secure the cover by installing the four screws in the back of
the cover.
Do not overtighten these screws.
(Figure
C-4):
RA0015A
Advertisement
Table of Contents
