Bay Networks 8000 RAC Installing Manual page 62

Chapter 2 Installing the Model 8000 Remote Access Concentrator
ROM Software Rev: 1122
Board ID: 64
CPU Type: 486DX2
Memory size: 8 Meg
Flash size: 4 Meg
Available Interfaces (* = selected): ThickNet *Twisted Pair
WAN 1: CAS E1
WAN 2: CAS E1
SLC 1
SLC 2
Installing the Model 8000 Remote Access Concentrator
2-18
4. Verify the RAC hardware configuration.
At the monitor:: prompt, type config and press
screen displays information similar to this:
REVISION/CONFIGURATION INFORMATION
SLC SRAM Size: 128 K
SLC SRAM Size: 128 K
5. Verify and record the RAC's Ethernet address for future
reference.
At the monitor prompt, type addr -d and press Return. The
screen displays information similar to this:
monitor:: addr -d
Ethernet address (hex): 00-80-2d-XX-XX-XX
Internet address: <uninitialized>
Subnet mask: 255.255.0.0
Broadcast address: 0.0.0.0
Preferred Load Host address: <any host>
Preferred Dump Host address: 0.0.0.0
Load/Dump Gateway address: 0.0.0.0
Type of IP packet encapsulation: <ethernet>
Load Broadcast: Y
Board Type: 8000
Ethernet Address: 00-80-2d-xx-xx-xx
EEPROM size: 65504
Flash ID:0089
Revision: VERSION CAS MGR=2.1
Revision: VERSION CAS MGR=2.1
Modem Count: 31
Modem Count: 31
Return . The
Modem Rev: 0
Modem Rev: 0