Erase - Bay Networks 8000 RAC Installing Manual

erase

The erase command erases the contents of nonvolatile memory
(EEPROM memory). Erasing EEPROM restores all parameters to factory
default values. The erase command does not erase the Ethernet address.
The syntax is:
erase
The erase command prompts for confirmation before erasing the
nonvolatile (EEPROM) memory.
Because the erase command erases the IP address, you may
need to use the addr command to reenter the RAC's IP address
before reloading any software. (If you are using BootP or
RARP, you should not set the IP address.)
The command display looks similar to this:
erase
monitor:: erase
Erase all non-volatile EEPROM memory? (y/n) [n]:: y
Erasing <65504 or 8160 bytes> of non-volatile memory.
Please wait...
.........................................
.........................................
.........................................
.........................................
Initialized checksum record installed
.
.
.
Installing the Model 8000 Remote Access Concentrator
Chapter 3 ROM Monitor Commands
16K->|Data 0x0
3-15