Command Descriptions; Table 3-1. Rom Monitor Commands - Bay Networks 8000 RAC Installing Manual

Chapter 3 ROM Monitor Commands

Command Descriptions

Installing the Model 8000 Remote Access Concentrator
3-2
Default or current values for parameters are displayed in brackets. For
example:
Enter broadcast address [132.245.6.255]:
At the prompt, enter a different value, or press Return to leave the
displayed value unchanged.
You can use unique abbreviations for all ROM Monitor commands except
erase. For example, enter boot as bo, and enter net as n. If you enter an
abbreviation that is not unique, an error message is displayed on the
console terminal.
Table 3-1 lists the ROM Monitor commands; the following sections
describe them.

Table 3-1. ROM Monitor Commands

Command
addr [-d]
allow_snmp_sets [-d]
boot [-v] [<file>]
boot [-l] [<file>]
(continued on next page)
Description
Displays and sets
EEPROM values
relevant to IP network
addressing, including the
unit's IP address.
Enables/disables the
RAC's ability to accept
SNMP sets.
Manually boots and loads
the unit's operating code.
Erases the existing flash
memory and copies a new
image to flash memory.
Use
Changing IP
configuration
parameters.
Allowing or not
allowing the RAC to
be configured using
SNMP sets.
Changing the address
of the boot image.
Upgrading or
replacing the flash
image.