Figure 2-8. Connecting A Console Terminal - Bay Networks 8000 RAC Installing Manual

Chapter 2 Installing the Model 8000 Remote Access Concentrator
Installing the Model 8000 Remote Access Concentrator
2-12
2. Plug the 8-pin connector into the console port located on the
back panel of the RAC
When the connector clicks into place, the connection is secure.
Appendix A describes the console port's signal/pin allocation.

Figure 2-8. Connecting a Console Terminal

3. Turn on the console terminal and set the terminal to 9600
baud, 8 data bits, no parity, 1 stop bit, and no flow control.
The ROM monitor assumes that this terminal is CRT-based and
displays the backspace (BS) character accordingly. See
Powering Up and Testing the Remote Access Concentrator on
page 2-17 for information about invoking the ROM monitor.
(Figure 2-8).
RA0011A