Bay Networks 8000 RAC Installing Manual page 114

Chapter 4 Troubleshooting Procedures
Installing the Model 8000 Remote Access Concentrator
4-16
When the RAC boots in Monitor mode, the console terminal displays the
load server host's IP address, and indicates whether it receives a response
to its open file request and to any of its read file requests. The host's
progress report indicates receipt of any file server requests and its
responses to such requests.
The host displays the message erpc_return 0 if it successfully receives a
request and is sending out an affirmative response. If any RAC-related
files are missing or cannot be installed, contact the Technical Solutions
Center.
Windows NT Host on the LAN
When troubleshooting a Windows NT host on the LAN, make sure that:
• The host is booted and functioning properly.
• The host can communicate with other network nodes using
standard Windows NT networking features and utilities.
• All RAC software is installed properly on the host. Refer to
Installing Remote Access Concentrator Software for
Windows and Windows NT ® for procedures to properly
install the software.
• The erpcd daemon or tftp server (which loads the
operational image to the RAC) is running.
In Test mode, erpcd on the load server host displays boot progress reports.
In Monitor mode, the RAC displays boot progress reports. The RAC
displays its reports on the console terminal that invokes its Monitor mode;
erpcd displays its reports on the terminal that invokes its Test mode.