Net - Bay Networks 8000 RAC Installing Manual

net

The net command executes an Ethernet transceiver loopback test on the
local area network. The command syntax is:
net
When you enter the net command, you are prompted as shown in the
following example:
monitor:: net
Is a loopback plug being used ? (y/n) [n]: n
This transceiver loopback test sends out a short test packet from the RAC
through the transceiver to test the integrity of the network.
The Ethernet transceiver loopback test causes the Net LED to turn off. If
the RAC passes this test, the console terminal displays PASSED, as shown
in the following example.
monitor:: net
Is a loopback plug being used ? (y/n) [n]: n
Network test - PASSED
If the RAC fails, the console terminal displays an error message. Failing
this test indicates that either the RAC or the Ethernet is bad.
Installing the Model 8000 Remote Access Concentrator
Chapter 3 ROM Monitor Commands
3-19