Bay Networks 8000 RAC Installing Manual page 69

Chapter 2
2. Enter the image command at the monitor prompt.
When prompted, enter the following information:
• Boot image name
• Boot directory
• Dump file name
The default image file name is:
The following example shows how the image command is used
to set up a RAC boot from the /tftpboot/annex/ directory. When
you enter the load directory name, make sure you end the path
name with a slash character.
Image name: <invalid or uninitialized> Default:
"oper.64.enet"
Enter Image name::oper.64.enet
Image name: "oper.64.enet"
TFTP load directory:
Enter TFTP load directory::/annex
TFTP Dump path/filename: <uninitialized> Default:
"dump.134.117.6.34"
Enter TFTP Dump path/filename::/annex/mydumpfile
Using current TFTP Dump path/filename.
monitor::
3. Execute the following commands to prepare the tftp dump
file.
touch /tftpboot/annex/mydumpfile
chmod 622 /tftpboot/annex/mydumpfile
Installing the Model 8000 Remote Access Concentrator
Installing the Model 8000 Remote Access Concentrator
oper.64.enet
2-25