Power-Up And Test - Bay Networks 8000 RAC Installing Manual

Power-up and Test

To run the Model 8000 RAC power-up and test sequence:
1. Reconnect all the cables, including:
• The Ethernet cable
• The WAN interface cables
• The console terminal cable
• Sync port cable (V.35, X.21, RS-422, or RS-232)
• The power cord
2. Turn on the unit's power.
3. Set the Model 8000 RAC to Setup mode by pressing the
Reset button momentarily
The RAC runs its ROM-resident power-up diagnostics.
4. At the monitor:: prompt, issue the config command to
verify the new hardware and modem configuration.
5. Issue the ports command and enter the number of ports to
be tested, as a range, at the prompt requesting the port list.
If the ports tests complete successfully, and the config
command indicates that the RAC recognizes the new modems,
the installation is complete.
Installing the Model 8000 Remote Access Concentrator
Appendix B Modem Upgrade Instructions
(Figure B-6).
B-9